|
More Info |
| JIMS
® is proud to offer 6-speed transmission gears made in the U.S.A. by
JIMS ® . Imagine riding the road at 75 MPH in 5th gear and by shifting
into 6th you reduce your engine RPM by almost 500 RPM.'s. It's now
possible to have this option with the strength and reliability of JIMS ®
quality gears and shafts. All gears are standard width for performance
and strength, with first gear being close ratio 2:94, and the last four
being the same ratio as a stock 5-speed. 6th gear goes to .86:01
over-drive. JIMS ® 100% American Made and assembled by JIMS ® American
Team. Run a 5-speed transmission in a 4-speed (non-rubber mount) type
frame. Be it stock or any aftermarket frame that will clear an electric
start. Now, your Panhead or Shovelhead (See applications on next page)
can have all the finer points of a 5-speed transmission with smooth
shifting, smooth quiet running and more H.P. from much lower friction
drag. This transmission will also allow you to control your gear ratio
for your style of riding. This way you can have a lower low and a higher
high. A sweet performance upgrade that will increase engine life,
acceleration and gas mileage. We start off with JIMS ® Gear Shafts with
gears having their dogs back cut with lead-in ramping on mating gears.
Installed in a Sputhe case using the most technologically advanced
assembly room known to the motorcycle aftermarket, topped off with JIMS
® Gaskets and seals. |
Technical
Notes:
Important Note: Complete Transmissions For 4-Speed Frames:
Fits Panhead 1936-65 Custom application with belt drive only, Shovelhead 1966-69 Custom application
with belt drive only, Shovelhead 1970-84 & early EVO Softail with dry clutch
|
|
